Home > FAQ > Waste Tire/Plastic Pyrolysis Plant>What is the working processing of continuous waste tire pyrolysis plant?
What is the working processing of continuous waste tire pyrolysis plant?
Waste Tire/Plastic Pyrolysis Plant / Date:July 19, 2017
Working processing of continuous waste tire pyrolysis plant
a.Waste tire pretreatment before feeding it into our continuous waste tire pyrolysis plant.
As the photo shows, the ring cutter, tire strip cutter and black cutter work together to firstly remove the tire bead and cut the left tire into rubber blocks, and then use steel wire separator to separate the steel wire out of the tire bead. The rubber blocks and the bead after steel wire separating will be used as raw material for our continuous waste tire pyrolysis plant. The steel wire got from the tire bead can be packaged and sold directly.
b.Heating in advance to make the temperature of the pyrolysis reactor rise up to about 300℃，fuel can be oil or gas, the heating is indirect heating by hot air produced by burners.
c.Turn on the auto-feeder, small tire pieces loaded into reactor and pyrolysis begins; when reach certain temperature the gas oil is generated from the waste tire.
d.Oil gas generated and condensed into fuel oil to be stored, sync gas recycled and used as fuel during operation; at the same time, carbon black and steel wires in short also discharged from the auto-discharge system. The steel metal and carbon black separated automatically and stored.
